DVR triggers “event recording” all the time

DVR triggers “event recording” all the time

1.      When turning on the DVR, the drive recorder will do adjustment based on the g-sensor. When the machine tilts, it will triggers event recording function.

2.      Please adjust the machine back to the power-on angle, click the menu to enter the function setting, click the system and choose reset the factory settings to complete the reset function.

    • Related Articles

    • MiVue C540 / C541 / C570 recording modes

      MiVue C540 / C541 / C570 recording modes Continuous recording When connected to the in car charger and the engine is turned on, the device will automatically switch on and by default, will start continuous recording after a few seconds. The ...

    • Setting the date and time on a MiVue M5xx-series

      Setting the date and time To ensure the accuracy of recorded date and time, make sure you set both before recording. Make sure the MicroSD card is inserted. Remove the protective cap. Connect your device to the PC and turn it on. The MiVue ...

    • Saving a NeverMiss location under recording mode

      During recording mode, the Cyclo map view will show an additional Pin button for you to mark a place. You can see the marked place after you upload the recorded track in the MioShare History page. You can use the re-edit button to save the marked ...

    • Recording and System Error on MiVue M510/M560

      Recording To start recording, press and hold the power button to turn the device on. Now press the power button again to start recording. When recording, the red LED light will start blinking. Press and hold down the power button again to stop ...

    • How to change the Time/Date on your MiVue 7-Series

      Changing the Time/Date on your MiVue To change the Time/Date on a MiVue 7-Series, you simply need to access the main menu of your device; Go to "Settings" > "System" > and select "Date/Time". This will allow you to choose the Time/Date settings to be ...